I got this computer tower that takes long 6-32 standoffs, which seem near impossable to find since I'm short on a few.
M3.5 (6-32)*10*3 are the stock standoffs.
I was thinking of replacing them with:
M4*10*6 Standoffs
M4*8 or M4*10 Screws
M4 Nut (extra thread gets nut'd under motherboard tray so standoffs stay in place)
My question is:
1) Will the M4 standoff thread fit it without havint to boare a bigger hole.
2) Will M4 screws be too fat to fit in motherboard screw holes?
Motherboard will be a standard ATX one.